316 Stainless Steel | Fastener Materails | Tri Suppli

316 Stainless Steel ASTM F593E

Grade 316 is the standard molybdenum-bearing grade, second in importance to 18-8 or 304 amongst the austenitic stainless steels. The molybdenum gives 316 better overall corrosion resistant properties than Grade 304, particularly higher resistance to pitting and crevice corrosion in chloride environments.

The specification below for ASTM F593E covers the requirements for 316 series stainless steel bolts, hex cap screws, and studs 0.25 to 1.50 in., inclusive, in nominal diameter in a number of alloys in common use and intended for service applications requiring general corrosion resistance.

 

  • Specification

    ASTM F593E

  • Mechanical Properties

    Head Marking F593E
    Diameter 1/4 to 1-1/2
    Tensile 65 to 85 ksi.
    Yield 20 ksi min
    Rockwell B85 max

  • Composition

    Carbon, 0.08% max.
    Manganese, 2.00% max.
    Phosphorus, 0.045% max.
    Sulfur, 0.030% max.
    Silicon, 1.00% max.
    Chromium, 16.00-18.00%
    Nickel, 10.00-14.00%
    Molybdenum, 2.00-3.00%

DISCLAIMER

All the information provided in this section has been assembled with concern for accuracy. It is intended for advisory purposes only and use of this information is completely voluntary. We do not guarantee its completeness or validity and assume no responsibility for any loss, claims or damages resulting from use or application of this information. All information is subject to change without prior notice. Be sure to verify!All the information provided in this section has been assembled with concern for accuracy. It is intended for advisory purposes only and use of this information is completely voluntary. We do not guarantee its completeness or validity and assume no responsibility for any loss, claims or damages resulting from use or application of this information. All information is subject to change without prior notice.